Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

wiring list

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RV10-List
View previous topic :: View next topic  
Author Message
rvdave



Joined: 24 Jan 2009
Posts: 191

PostPosted: Fri Dec 02, 2011 5:54 pm    Post subject: wiring list Reply with quote

Getting back to working on the 10 after remodeling work at home, am getting ready to order some wiring and items for fwf to aft fuselage so I can close things up and have compiled a list of things, wondering if anyone can see what I'm missing. So far the only thing I have running back is static line.

18' #2 cable
30 ' 7 conductor shielded cable- 1 for servo, 1 extra
18' antenna cable
battery contactor
starter contactor
misc crimp connectors for #2 cable


- The Matronics RV10-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

_________________
Dave Ford
Cadillac, MI
Back to top
View user's profile Send private message Send e-mail
nukeflyboy



Joined: 05 Jan 2008
Posts: 162
Location: Granbury, TX

PostPosted: Fri Dec 02, 2011 6:54 pm    Post subject: Re: wiring list Reply with quote

Dave,
If you mean what to run forward to aft in terms of cables and wires, here are things to consider.
1. Power and ground to tail light. This will be dictated by the type of light(s), ie, strobe, incandescent, or LED. Note that strobe/LED can be synchronized which adds a wire.
2. Pitch servo - 7 wires
3. Elevator trim - 5 wires
4. Some AHRS units and magnetometers go back there. This could be several wire bundles. I recommend installing conduit for pulling wires later.
5. Remote mounted transponder and/or ADS-B could go back there.
6. Pos and ground battery wires to starter and engine or common grounding point.
7. Power from battery to main buss(es).
8. Coax for comm antenna(s).
9. Multiple conductor to ELT. Shielded 2 pair for GPS feed, power, and phone type cable to control ELT from panel switch.
10. Passenger headsets
11. Lights, power outlets, or anything else mounted back there.
12. Door reed switch wires
13. Battery master contactor wire
14. More wires if you are installing 2 batteries or a cross-feed connector
15. Transponder coax

If you want to include wing wires, then there are more.
What about oxygen system plumbing?


- The Matronics RV10-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

_________________
Dave Moore
RV-6 built and sold
RV-10 built and flying
Back to top
View user's profile Send private message Send e-mail
kearney



Joined: 20 Sep 2008
Posts: 563

PostPosted: Fri Dec 02, 2011 7:10 pm    Post subject: wiring list Reply with quote

Dave

Here are the things going to my tail.

Magnometer wiring - 2
Elt wiring
Comm Antenna coax - 2
GPS antenna coax
Nav antenna coax
O2 lines to bottle in baggage area
Wiring for vent to rear of overhead plenum
Wiring for cabin lights in overhead plenum
Wiring for rudder trim
Wiring for elevator trim
Wiring for autopilot pitch servo
Wiring for tail light
Wiring to Whalen lighting system power supply and return lines for wing nav lights

I ran conduit along the sides to aft if the baggage area. One per side. It would have been better to have a couple of lines per side.

Cheers

Les

Sent from my iPhone

On 2011-12-02, at 6:54 PM, rvdave <davidbf(at)centurytel.net> wrote:

Quote:


Getting back to working on the 10 after remodeling work at home, am getting ready to order some wiring and items for fwf to aft fuselage so I can close things up and have compiled a list of things, wondering if anyone can see what I'm missing. So far the only thing I have running back is static line.

18' #2 cable
30 ' 7 conductor shielded cable- 1 for servo, 1 extra
18' antenna cable
battery contactor
starter contactor
misc crimp connectors for #2 cable

--------
Dave Ford
RV6 flying
RV10 building
Cadillac, MI




Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=360088#360088












- The Matronics RV10-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> RV10-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group