bssailor(at)bellsouth.net
Guest
|
 Posted: Sat Jan 17, 2015 9:44 am Post subject: Z-9 diagram for Corvair |
 |
|
Bob,
I'm building a Zenith 601XLb with a Corvair engine. I'm using the Z-9
diagram, the Corvair/601 Engine Installation Manual By William Wynne and The
AeroElectric Connection 12A as guides/references.
My intentions are mostly fun flying with trips to visit family and
interesting places. It will be day VFR.
My desires are reliability first and foremost.
I have a Dynon EFIS-D100, a EMS-D120, Garmin GTX-327, Icom IC-A210, and
Garmin aera all installed, wired and tested. This was all pretty straight
forward. I'm using tefzel wire, PDIG connectors and the correct crimpers for
all of this.
I'm into the charging system now, and since the ignition system is
battery/alternator powered instead of magneto, my desire is to have a
reliable charging system. If the charging system is malfunctioning, I want
to know about it as soon as possible.
I have the John Deere MIA10338 Alternator and the MIA881279
Rectifier/Regulator. The alternator is a permanent magnet type with single
phase A.C. output coming out of the alternator.
Thanks,
Billy Stewart
--
| | - The Matronics AeroElectric-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?AeroElectric-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
